
ServicesGutter Installation
Gutter Installation in Edisto Beach
We install new gutters sized to your roof, pitched so water runs to the outlets, and fastened with hidden hangers into solid fascia. Every day ends with cut-offs, rivets and loose screws picked up, so your yard and driveway look the way we found them.
When Replacement Beats Patching
Gutters exist to collect the water running off your roof and carry it clear of the fascia, siding and foundation. Once the troughs are too small for the roof, sag along most of their length, or show corrosion at seam after seam, fixing one spot only shifts the leak a little farther down the run. At that stage a full replacement costs less over the years than a string of repairs.
If all you have is one loose hanger or a single dripping corner, our Gutter Repair page covers that work, and we will say so plainly when a repair is enough. We have been in business 8 years, and most of our installs begin with that straight assessment of what is really failing.
We count the property as part of the job. Plantings get covered, ladders get standoffs so they never lean on the new metal, and a magnet goes over the ground before we leave each day.
What Our Gutter Installation Includes
Sizing to the roof
We measure roof area and pitch to choose between 5-inch and 6-inch K-style troughs. A steep roof or a long valley that dumps into one corner needs more capacity than the square footage alone suggests.
Proper pitch
Each run is set to fall roughly a quarter inch per 10 feet toward its outlet. Too flat and water sits, too steep and it overshoots the corner in a hard rain.
Hidden hangers into solid wood
We space hangers closely and drive their screws into the fascia, reaching the rafter tails behind it wherever we can. Long nails pushed through a sleeve, the way many older gutters were hung, work loose as the boards take on moisture and dry out again. Threaded screws keep their grip through those cycles.
Metals that suit salt air
We match aluminum troughs with compatible fasteners so dissimilar metals are not touching. Mixing metals near the coast invites galvanic corrosion that eats seams and hanger points within a few seasons.
Sealed corners and end caps
Miters, end caps and outlets are riveted and sealed with gutter sealant rated for outdoor movement, so joints flex with temperature swings instead of cracking open.
Daily cleanup
Old gutters are hauled off, metal shavings and cut-offs are bagged, and a magnetic sweeper goes over the lawn, beds and driveway at the end of every workday.
Signs Your Home Needs New Gutters
Water pours over the front edge
During a summer downpour, sheets of water spilling over the lip usually mean the troughs are too small or have lost their pitch.
Gutters pulling off the fascia
A visible gap between the back of the gutter and the board, or hangers backing out, means the fastening has failed along the run.
Corrosion at seams and hangers
White powder on aluminum or rust streaks on steel at the joints shows the metal is breaking down from the inside out.
Soft or stained fascia
Dark streaks and spongy wood behind the gutter mean water has been running behind it for a while.
Washed-out soil along the foundation
Trenches in the mulch, splashback on the siding and pooling near the slab all point to water not being carried where it should go.
How Installation Day Runs
- 1
Free estimate and walk-through
We measure every run, check the fascia and drip edge, and take photos of anything that concerns us. You get a written, line-item estimate that shows what is being replaced and why.
- 2
Protect the property
Before any metal comes down, we lay tarps over beds and shrubs, cover outdoor units under the eaves, and set ladder standoffs so nothing leans on siding or windows.
- 3
Remove and inspect
Old gutters come off and we look at the bare fascia. If we find rot, we show you photos and talk through it before anything new goes up.
- 4
Hang, pitch and seal
New troughs are snapped to a chalk line for pitch, hung, and sealed at every corner and outlet. We run a hose along each section to confirm water flows to the outlets.
- 5
Final sweep and walk-around
We do one last magnet pass, haul away all debris and walk the house with you so you can see the finished work.
What Moves the Price
Every home is priced from its own measurements, so we do not quote over the phone without seeing it. The free estimate breaks out materials, labor and haul-away on separate lines. These are the things that change the number most.
- Length and corners
- Total linear feet sets the base, but each inside or outside corner adds a mitered joint that takes time to cut and seal.
- Height and access
- Two-story eaves and homes raised on pilings need taller ladders or staging, which adds setup time on every side of the house.
- Trough size and metal gauge
- Six-inch troughs and heavier-gauge aluminum cost more than standard sizes but carry more water and resist denting.
- Fascia condition
- Rotted boards have to be dealt with before new gutters can hold. We document what we find so you can see the reason for any change.
- Add-ons at the same visit
- Adding Gutter Guards, Gutter Covers or Rain Chains while the crew is already set up costs less than a separate trip later.
Gutter Installation Questions
Something not covered here? (843) 883-4411
How many days will the install take?
A typical one-story house is done within a single workday. Two-story homes, houses raised on pilings and rooflines with lots of corners can stretch into a second day. If the job spans two days, we still pick up and sweep before we leave that first evening.
Should I choose aluminum or steel near the coast?
For most homes here we recommend aluminum, since it does not rust in salt air the way steel can. The larger risk is putting different metals in contact, so we keep the fasteners and hangers compatible with the troughs. We walk through the tradeoffs with you during the estimate.
What warranty comes with a new install?
Every installation we do is backed by a 2-year workmanship warranty. If a seal we made at a corner opens or a hanger we set pulls loose because of how it was put in, we return and fix it.
Will your crew damage my landscaping?
Tarps go over beds and shrubs before anything comes off the roofline, and ladders sit on boards where the ground is soft. Cut-offs are never tossed into planting areas. The magnet sweep at the end of the day catches the small screws and rivets that would otherwise turn up underfoot weeks later.
Can you add guards or covers at the same time?
Yes. Fitting gutter guards or gutter covers while the new troughs go up lets us match them to the exact profile and hanger spacing. It also spares you a second setup at your home.

Get New Gutters Without the Mess
We have been in business 8 years and earned an Angie's List Super Service Award in 2018. Tell us about your home and we will set up a walk-through, measurements and a written estimate.